On Monday 20 August 2018 10:41:23 Dr. Nikolaus Klepp wrote:

> Am Montag, 20. August 2018 schrieb Gene Heskett:
> > [...]
> > These guys make a pretty good installer simply because they know
> > what it needs and doesn't need to run LinuxCNC right. They don't
> > care if it doesn't run on cousin Molly's washing machine, although
> > with some config effort, it can probably run it, better than the
> > programming it came with.
> >
> > I certainly had no such problems installing tde on top of the kde I
> > originally loaded onto my Dell running a grizzly G0704 mill on a
> > special wheezy install.  So I'll do the same and then install tde on
> > that.
> >
> > Back later with grins or tears.
> >
> > Thanks Michelle.
>
> Hi Gene!
>
> You should definitly walk the devuan road. I had a hell of a time with
> machinekit on BBB, till I found out how to get rid of the systemd
> stuff. When you run stretch + linuxcnc, you'll most likely get bad
> surprises (aka. latency > 400000ns) with the 4.*-rtpreempt kernel
>
> Nik

Its tears so far Nik. There are so many differences just in the ext4's 
used that one of them should be renamed, they will NOT cross mount, ext4 
disk to ext4 mount.



-- 
Cheers, Gene Heskett
--
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
Genes Web page <http://geneslinuxbox.net:6309/gene>