Hi Kate, On Saturday 08 December 2018 20:37:33 Kate Draven wrote: > > Hi Guys, > > > > Probably nothing to do with this problem, but anyway: > > > > If I have a HDD connected via a USB adaptor, I've found that > > after an initial plugging and use, then safely removing it, going > > back to it, in the same session, it may or may not be recognised. > > Doing a hard reboot seems to clear what ever causes this. > > Simply logging out and logging back in doesn't seem to work. > > > > > > -- > > Best Regards: > > Baron > > > > ----------------------------------------------------------------- > >---- > > I've seen this before. Sometimes it just helps to plug out the unit > out and do the following. > > If you can, power it down, then connect it, power it back up. > If it works, it's like the unit. If it doesn't, then it's software. > > Another thing you can try is to wait for a few mins, until the > drive spins up, plug it out, wait 10s plug in again. > > It could be the drive is really slow to spin up. > > Good luck, let us know what happens. > > Kate Thank you for your reply. I must admit I didn't wait and logging out and re booting takes several seconds. -- Best Regards: Baron