2015-02-04 13:56 GMT+01:00 Sl�vek Banko <slavek.banko@...>: > Dne st 4. �nora 2015 Nicolas Dobigeon napsal(a): >> 2015-02-04 13:22 GMT+01:00 Lisi Reisz <lisi.reisz@...>: >> > On Wednesday 04 February 2015 12:14:43 Nicolas Dobigeon wrote: >> > > All worked with the base desktop (Gnome) but when i installed an used >> > > TDE, it can't play any sound with ARTS. >> > > I don't know how to correct it. >> > >> > I always have trouble with sound in everything. The problem is usually >> > that sound is muted somehwere, especially if I know that it is basically >> > working, as you do; and I just have to find where it is muted. >> > >> > Most obvious first - have you looked at KMix? Alsamixer? Pavucontrol? >> > (In that order! And you may not have all of them.) >> > >> > Lisi >> >> It was OK on Kmix, nothings was muted. >> I didn't look on alsamixer yesterday but i think the items are the sames. >> Pulseaudio isn't installed ... then no this way. >> >> I'll look to this point again and reply to the list with the result. >> Also, i'll send the lspci output. >> >> Is it possible that the default sound output with ARTS is my secondary >> HDMI output ? Even if nothing in pluged in ? >> >> Nicolas D. >> > > Try: cat /proc/asound/cards > By default output go to the card number 0. > > -- > Sl�vek Hi, # lspci 00:03.0 Audio device: Intel Corporation Haswell-ULT HD Audio Controller (rev 09) 00:1b.0 Audio device: Intel Corporation 8 Series HD Audio Controller (rev 04) # cat /proc/asound/cards 0 [HDMI ]: HDA-Intel - HDA Intel HDMI HDA Intel HDMI at 0xb0610000 irq 66 1 [PCH ]: HDA-Intel - HDA Intel PCH HDA Intel PCH at 0xb0614000 irq 64 It seems that my HDMI output is the main input. How can i change it to the card PCH ? Thanks.