Message: previous - next
Month: August 2018

Re: [trinity-users] stretch problems

From: "Dr. Nikolaus Klepp" <office@...>
Date: Mon, 20 Aug 2018 16:41:23 +0200
Am Montag, 20. August 2018 schrieb Gene Heskett:
> [...]
> These guys make a pretty good installer simply because they know what it 
> needs and doesn't need to run LinuxCNC right. They don't care if it 
> doesn't run on cousin Molly's washing machine, although with some config 
> effort, it can probably run it, better than the programming it came 
> with.
> I certainly had no such problems installing tde on top of the kde I 
> originally loaded onto my Dell running a grizzly G0704 mill on a special 
> wheezy install.  So I'll do the same and then install tde on that.
> Back later with grins or tears.
> Thanks Michelle.

Hi Gene!

You should definitly walk the devuan road. I had a hell of a time with machinekit on BBB, till I found out how to get rid of the systemd stuff. When you run stretch + linuxcnc, you'll most likely get bad surprises (aka. latency > 400000ns) with the 4.*-rtpreempt kernel


Please do not email me anything that you are not comfortable also sharing with the NSA, CIA ...